DIY Agate Slice Drink Coasters
On a recent trip to one of my favorite gem supply shops in the Portland area (Ed’s House of Gems as I wrote in an earlier post here) I found some pretty agate slices that seemed like they would be perfect for drink coasters. Sure, I got the idea from Rablabs many years back…but those coasters were $65 at the time and way more than I wanted to spend. So I decided to make my own DIY agate drink coasters – with a little metal leaf to glam them up – and some cork “feet” to protect my table. You can find agate or geode slices many places now (including at your local Michael’s or Jo-Ann Fabrics stores!) and you can buy them on eBay or here as well. I also shared this project idea on Darby Smart awhile ago…but I figured it was high time to turn it into a full-fledged tutorial. So here it is!
You Need:
agate slices (you can use dyed agate though the dye may bleed a little) / Mod Podge or metal leafing glue / clean, soft brush / metal leaf sheet in your favorite metal color / adhesive cork disks (find these in the furniture protection section!) / small scissors / adhesive sealant (optional, not pictured)
How To:
1. Brush the edges of an agate slice with Mod Podge or metal leafing glue. (If your agate is dyed, you may find that the color starts bleeding into the glue here.)
2. Allow the glue to dry a few minutes so it is tacky. Roll onto a metal leafing sheet, pressing hard and covering all edges completely with the sheet. Just rip and reposition!
3. Making sure your brush is completely dry (or just use a different brush), gently brush off the excess metal leaf.
4. Usually the adhesive cork disks that are sold for furniture are too large for coasters, so cut each disk into smaller pieces.
5. Place the cork pieces at opposite ends of the agate slice so the slice will sit level on a flat surface.
And that’s it! 
Pretty, colorful, organic coasters add a touch of class to any decor. If you’re concerned about the metal leaf coming off with use or exposure to liquids, I’d advise a quick spray of acrylic sealant around the edges of the coasters to make that permanent.
These coasters look so lovely shimmering in pale colors below translucent drinks!
What do you think? Is this a project you’ll be trying out?
xo
Carly
Leave Comment
